Test of Cable Products in Respect of Thermal and Dynamic Stability
Abstract
The paper considers conditions for selection of power supply of the unit which is used for testing samples of cable products by thermal and dynamic stability currents. It has been shown that while conducting testing by thermal and dynamic stability currents at nominal cable voltage it is more justifiable to use a percussive energy accumulator, and in the case when the voltage is low an inductive energy accumulator is used.
About the Authors
M. A. Korotkevich
Belarusian National Technical University
Belarus
Belarus
I. V. Oleksiouk
Belarusian National Technical University
Belarus
Belarus
References
1. Муфты для силовых кабелей на напряжение до 35 кВ включительно : ГОСТ 13781.0–86. – Взамен ГОСТ 13781.0–79, ГОСТ 23953.0–80 ; введ. 24.06.86. – М. : Изд-во стандартов, 1986. – 18 с.
2. Пичугина, М. Т. Мощная импульсная энергетика / М. Т. Пичугина. – Томск : Изд-во ТПУ, 2005. – 98 с.
3. Накопители энергии : учеб. пособие для вузов / Д. А. Бут [и др.] ; под ред.Д. А. Бута. – М. : Энергоатомиздат, 1991. – 400 с.
4. Проектирование распределительных электрических сетей : учеб. пособие / Г. А. Фадеева, В. Т. Федин ; под общ. ред. В. Т. Федина. – Минск : Вышэйш. шк., 2009. – 365 с.
Review
For citations:
Korotkevich M.A., Oleksiouk I.V. Test of Cable Products in Respect of Thermal and Dynamic Stability. ENERGETIKA. Proceedings of CIS higher education institutions and power engineering associations. 2010;(1):25-32. (In Russ.)
Views:
748
Email this article 