HEAT DISSIPATION ON THE LATERAL SURFACE OF CYCLONE CHAMBER WITH ASYMMETRICAL TWO-WAY GAS INPUT AND OUTPUT
Abstract
The heat dissipation on the lateral surface of the cyclone chamber working volume with asymmetrical input and output of gases is considered in the present paper in contrast to the previously executed [1–10]. The relative values of input gas flow and the relative diameters of the outlet are different in each of the halves of the working volume. The heat dissipation by convection to the swirling airflow was studied by the method of variation of the aggregate state of the heating agent – water vapor slightly superheated (at 2–3 °С) condensation. Collecting the condensate produced from the work site through a water lock, providing maintaining of constant pressure in the calorimeter. The quantity of heat transmitted during the experiment was determined by the amount of collected condensate.
In the experiments on the camera with two-sided asymmetric output relative gas outlet diameter on one side of the camera varied Relative diameter of the outlet on the other hand remained constant. In the experiences on the camera with the bilateral asymmetrical conditions for the introduction of gases the asymmetry of the introduction of flow was created due to a change in the relative entrance area whoo remained constant. Local heat transfer coefficient was determined for different values dimensionless longitudinal coordinate coinciding with the axis of the chamber, directed toward the outlet, measured from the middle section of the working volume. Еquations for calculation of heat transfer coefficients on the lateral surface of the howling cyclone chambers with unbalanced input and output gases, оbtained in this paper, give the satisfactory agreement of the calculated and experimental data that allows to recommend to their practical application.
About the Authors
E. N. Saburov
Northern (Arctic) Federal University
Russian Federation
Russian Federation
Professor, PhD in Engineering
N. V. Smolina
Northern (Arctic) Federal University
Russian Federation
Russian Federation
Associate Professor, PhD in Engineering
References
1. Saburov, E. N. (1995) Cyclone Heat Devices with Intensive Convective Heat Exchange. Arkhangelsk, North–East Publishing House. 344 p. (in Russian).
2. Saburov, E. N., Karpov, S. V., Smolin , N. V. (1998) Investigation of Heat Dissipation on the Lateral Surface of the Cyclone Chamber Working Volume with Two-Side Face Output of Gases. Izvestiia Vysshikh Uchebnykh Zavedenii i Energeticheskikh Ob’Edinenii – Energetika. [Proceedings of the Higher Education Institutions and Power Engineering Associations – Power Engineering], 4, 49–54 (in Russian).
3. Saburov, E. N (1998) Heat Dissipation on the Lateral Surface of the Cyclone Chamber of Big Length. Trudy Vtoroi Rossiiskoi Natsional’noi Konferentsii po Teploobmenu [Proceedings of the Second Russian National Conference on Heat Transfer ]. Moscow, Publishing House of Moscow Power Engineering Institute , 224–227 (in Russian).
4. Saburov, E. N., Karpov, S. V., Smolina, N. V. (1999) Heat Dissipation on the Lateral Surface of the Cyclone Chamber Working Volume With Two-Side Face Output of Gases. Izvestiia Vuzov. Lesnoi zhurnal [Isvestiya(News) of Higher Educational Establishments. Forestry Journa], 2–3. – 216–224 (in Russian).
5. Saburov, E. N. (2011) Convective Heat Dissipation in Cyclone Heat Devices. Part 1 Fundamentals of Convective Heat Dissipation. Arkhangelsk, Publishing House of Northern (Artic) Federal University. 385 p. (in Russian).
6. Saburov, E. N., Ostashev, S. I. (2004) Convective Heat Dissipation in Cyclone Sectional Heat Devices. Arkhangelsk, Publisher Arkhangelsk State Technical University. 192 p. (in Russian).
7. Karpov, S. V. (2002) Aerodynamics and Convective Heat Dissipation in Cyclone Sectional Heat Devices. Povyshenie Effektivnosti Teploobmennykh Protsessov i System. Materialy III Mezhdunarodnoi Nauchno-Tekhnicheskoi Konferentsii [Efficiency Increasing of Heat–Exchange Processes and Systems: Materials of III International Scientific Technical Conference]. Vologda: Vologda State Technical University, 11–17 (in Russian).
8. Saburov, E. N., Smolina, N. V. (2012) Investigation of Local Heat Dissipation on Surface of Working Volume of Cyclone Chamber. Sbornik Trudov VII Mezhdunarodnoi Nauchno-Tekhnicheskoi Konferentsii “Avtomatizatsiia i Energosberezhenie” [Book of Works VII Intern. sc. techn. conference “Automatization and Energy-Savings”]. Vologda, 21–24 (in Russian).
9. Ostashev, S. I., Saburov, E. N. (2009) Calculation Methods of Cyclone Sectional Heat Devices. Sovremennaia Nauka i Obrazovanie v Reshenii Problem Ekonomiki Evropeiskogo Severa: Materialy Mezhdunar. Nauch.-Tekhn. Konf., Posviashchennoi 80-letiiu ALTI–AGTU [Modern Science and Education in Problems Solution of European North: Materials of International Scientific Research Conference, Devoted to 80th Anniversary of Arkhangelsk State Technical University]. Arkhangelsk, ASTU, 59–63 (in Russian).
10. Zaiceva, M. L., Orekhov, A. N. Saburov, E. N. (2013) Heat Dissipation on the Lateral Surface of the Cyclone Chamber of Big Length. Problemy Gazodinamiki i Teplomassoobmena v Energeticheskikh Ustanovkakh. Trudy XIX Shkoly-Seminara Molodykh Uchenykh i Spetsialistov pod Rukovodstvom Akad. A. N. Leont'eva [Problems of Gas-Dynamics of Heat-Mass Exchange in Power Plants. Works of XIX Training Seminar of Young Scientists and Specialists Guided by A. N. Leonteva]. Moscow, Publishing House Moscow Economic Institute, 148–151 (in Russian).
Review
For citations:
Saburov E.N., Smolina N.V. HEAT DISSIPATION ON THE LATERAL SURFACE OF CYCLONE CHAMBER WITH ASYMMETRICAL TWO-WAY GAS INPUT AND OUTPUT. ENERGETIKA. Proceedings of CIS higher education institutions and power engineering associations. 2014;(4):56-62. (In Russ.)
Views:
1778
Email this article 