Determination of Optimal Parameters of the Ground Filling During the Laying of Power Cable Lines
https://doi.org/10.21122/1029-7448-2026-68-2-128-139
Abstract
The present article discusses the problem of the technical and economic efficiency of using materials with increased thermal conductivity when filling trenches of power cable lines. The specific thermal resistance of the soil significantly affects the permissible cable currents and, as a result, the choice of their cross-section. When the soil dries out or it is initially of high thermal resistance, the carrying capacity of the conductors decreases, which often forces the use of cables with a larger cross-section to provide the required load current. One of the ways to improve cooling conditions is to use a special backfill with lower thermal resistance values, which is more expensive than the ground one. This raises the question of the feasibility of such a solution, since more expensive materials may not pay off in some cases. An optimization technique is proposed based on the calculation of reduced costs, taking into account the cost of cable, line construction and operating costs. The model that has been developed takes into account the influence of both normal and post-emergency operation modes. It is shown that increasing the cable current capacity due to special backfilling can reduce the cable cross-section by one step and, thus, compensate for the cost of more expensive material. Otherwise, the use of special backfills becomes impractical. To solve the optimization problem, a genetic algorithm implemented in the MS Excel environment was used. The results of calculation examples are presented, showing that the proposed methodology and algorithm can be used for various voltage and laying conditions, allowing the designer to select effective parameters of the cable line design.
About the Author
M. E. Vysotski
Belarusian National Technical University
Belarus
Belarus
Address for correspondence:
Vysotski Maksim E. –
Belаrusian National Technical University,
65/2, Nezavisimosty Ave.,
220013, Minsk, Republic of Belarus.
Tel.: +375 33 661-76-75
elsyst@bntu.by
References
1. Weedy B. (1980) Underground Transmission of Electric Power. New York , John Wiley and Sons. 232.
2. Bronguleeva M. N., Gorodetskii S. S. (1963) High Voltage Cable Lines. Leningrad; Moscow, Gosenergoizdat Publ. 512 (in Russian).
3. Anders G. J. (2005) Rating of Electric Power Cables in Unfavorable Thermal Environment. John Wiley & Sons: Hoboken, NJ, USA.
4. Ocłon P. (2021) Renewable Energy Utilization Using Underground Energy Systems. Lecture Notes in Energy. Vol. 84. Springer International Publishing, Cham, Switzerland. 173 p. https://doi.org/10.1007/978-3-030-75228-6.
5. Leon F. de, Anders G. J. (2008) Effects of Backfilling on Cable Ampacity Analyzed with the Finite Element Method. IEEE Transactions on Power Delivery, 23 (2), 537–543. https://doi.org/10.1109/TPWRD.2008.917648.
6. Gouda O. E., El Dein A. Z., Amer G. M. (2011) Effect of the Formation of the Dry Zone Around Underground Power Cables on Their Ratings. IEEE Transactions on Power Delivery, 26 (2), 972–978. https://doi.org/10.1109/TPWRD.2010.2060369.
7. Gouda O. E., El Dein A. Z. (2015) Improving Underground Power Distribution Capacity Using Artificial Backfill Materials. IET Gener. Transm. Distrib., 9 (15), 2180–2187. https://doi. org/ 10.1049/iet-gtd.2015.0274.
8. Ocłoń P., Rerak M., Rao R. V., Cisek P., Vallati A., Jakubek D., Rozegnał B. (2021) Multiobjective Optimization of Underground Power Cable Systems. Energy, 215 (part B), 119089. https://doi.org/10.1016/j.energy.2020.119089.
9. Ocłoń P., Cisek P., Matysiak M. (2021) Analysis of an Application Possibility of Geopolymer Materials as Thermal Backfill for Underground Power Cable System. Clean Technologies and Environmental Policy, 23, 869–878. https://doi.org/10.1007/s10098-020-01942-8.
10. Ocłoń P. (2021) The Effect of Soil Thermal Conductivity and Cable Ampacity on the Thermal Performance and Material Costs of Underground Transmission Line. Energy, 231, 120803. https://doi.org/10.1016/j.energy.2021.120803.
11. Czapp S., Ratkowski F. (2021) Optimization of Thermal Backfill Configurations for Desired High-Voltage Power Cables Ampacity. Energies, 14 (5), 1452. https://doi.org/10.3390/en14051452.
12. Cichy A., Sakowicz B., Kaminski M. (2018) Economic Optimization of an Underground Power Cable Installation. IEEE Transactions on Power Delivery, 33 (3), 1124–1133. https://doi.org/10.1109/TPWRD.2017.2728702.
13. Cichy A., Sakowicz B., Kaminski M. (2018) Detailed Model for Calculation of Life-Cycle Cost of Cable Ownership and Comparison with the IEC formula. Electric Power Systems Research, 154, 463–473. https://doi.org/10.1016/j.epsr.2017.09.009.
14. Pospelov G. E., Fedin V. T., Lychev P. V. (2004) Electrical Systems and Networks. Minsk, Technoprint Publ. 720 (in Russian).
15. Gerasimenko A. A., Fedin V. T. (2023) Electrical Systems and Networks. Rostov-on-Don, Feniks Publ. 473 p. (in Russian).
16. IEC 60287-3-2:2012. Calculation of the current rating. Part 3–2: Section on Operating Conditions – Economic Optimization of Power Cable Size. Geneva, IEC, 2012. 42 p.
17. Vysotski M. E. (2024) The Choice of a Construction Arrangement for Cable Lines with a Voltage of 10 kV According to the Criterion of the Minimum Expected Cost. Enеrgеtika. Izvestiya Vysshikh Uchebnykh Zavedenii i Energeticheskikh Ob’edinenii SNG = Energetika. Proceedings of CIS Higher Education Institutions and Power Engineering Associations, 67 (6), 488–500. https://doi.org/10.21122/1029-7448-2024-67-6-488-500 (in Russian).
18. Heat-conducting Concrete. Heidelberg Materials. Available at: https://www.heidelbergmaterials.co.uk/en/ready-mixed-concrete/heat-conducting-concrete.
19. TKP 611-2017: 6-110 kV Power Cable Lines. Design Standards for Laying Cables Insulated with Cross-Linked Polyethylene Peroxide Crosslinking. Minsk, Ministry of Energy of the Republic of Belarus, 2017. 103 p. (in Russian).
20. IEC 60287-1-1:2023. Electric Cables – Calculation of the Current Rating. Part 1–1: Current Rating Equations (100 % Load Factor) and Calculation of Losses – General. Available at: https://standards.iteh.ai/catalog/standards/iec/164f72dc-b67a-496b-af43-97e28a944a7b/iec-60287-1-1-2023.
21. IEC 60287-2-1:2023. Electric Cables – Calculation of the Current Rating. Part 2–1: Thermal Resistance – Calculation of Thermal Resistance. Available at: https://standards.iteh.ai/catalog/ standards/iec/9a2a6795-afb1-4194-97ae-9eef8d36e808/iec-60287-2-1-2023.
22. El-Kady M. A., Horrocks D. J. (1985) Extended Values for Geometric Factor of External Thermal Resistance of Cables in Duct Banks. IEEE Transactions on Power Apparatus and Systems, PAS-104 (8), 1958–1962. https://doi.org/10.1109/TPAS.1985.318767.
23. Gladkov L. A., Kureichik V. V., Kureichik V. M. (2010) Genetic Algorithms. 2nd ed. Moscow, FIZMATLIT Publ. 368 (in Russian).
24. Bramm A. M., Khalyasmaa A. I., Eroshenko S. A., Matrenin P. V., Papkova N. A., Sekatski D. A. (2022) Topology Optimization of the Network with Renewable Energy Sources Generation Based on a Modified Adapted Genetic Algorithm. Enеrgеtika. Izvestiya Vysshikh Uchebnykh Zavedenii i Energeticheskikh Ob’edinenii SNG = Energetika. Proceedings of CIS Higher Education Institutions and Power Engineering Associations, 65 (4), 341–354. https://doi.org/10.21122/1029-7448-2022-65-4-341-354 (in Russian).
25. Trautmann N., Gnägi M. (2015) On an Application of Microsoft Excel's Evolutionary Solver to the Resource-Constrained Project Scheduling Problem RCPSP, 2015 IEEE International Conference on Industrial Engineering and Engineering Management (IEEM), Singapore, 646–650. https://doi.org/10.1109/IEEM.2015.7385727.
26. Keisler J. M. (2024) Optimization: Excel Solver. Prescriptive Analytics. Springer Texts in Business and Economics. Springer, Cham. https://doi.org/10.1007/978-3-031-59353-6_10.
Review
For citations:
Vysotski M.E. Determination of Optimal Parameters of the Ground Filling During the Laying of Power Cable Lines. ENERGETIKA. Proceedings of CIS higher education institutions and power engineering associations. 2025;68(2):128-139. (In Russ.) https://doi.org/10.21122/1029-7448-2026-68-2-128-139
Views:
235
Email this article 