Optimization of the Operation of Groundwater Intakes Using Two-Column Wells

The average number of wells at a typical water intake is 30–40; while the power of the submersible pump is usually 32–40 kW; which means that only at one well water intake the power consumption of electric pumping equipment during the hours of greatest water consumption can reach 900–1600 kW. In the structure of operating costs of well water intakes; the share of electricity costs reaches 85 %. Taking into account the requirements for reducing costs and water tariffs of housing and communal services enterprises as well as of water utilities; energy saving is an urgent task. The article considers the optimization of the operation of groundwater intakes with uneven water supply due to the use of two-column water intake wells instead of typical single-column ones. It is shown that the use of powerful pumps in single-column wells of such water intakes causes a sharp decrease in the dynamic water level in the borehole. On the one hand; this provokes the formation of colmating deposits in the filters due to their aeration; reduces the specific flow rate of the well and shortens the intervals between regenerations. On the other hand; this increases the geometric pressure of submersible pumps and energy consumption for lifting water. The theoretical foundations of determining the supply of pumps installed in single- and two-column water intake wells supplying water to the pressure filter of the water treatment plant are considered. An example of a comparative analysis of the operation of one working well with one powerful pump as part of a water intake of two single-column wells (working and reserve) to cover the entire water supply schedule and two two-column working wells containing one less powerful pump in each column is given. The energy efficiency of these pumping systems is investigated. As a result of calculations; it was found that when combining the operation of pumps of two-column wells during periods of peak; main and partial loads; the annual energy savings will amount to 33 %.

1. Veremenyuk V. V., Ivashechkin V. V., Krytskaya V. I. (2020) The Borehole Water Intakes Mathematical Models with a Branched and Circular Connection Schemes for Prefabricated Water Conduits. Enеrgеtika. Izvestiya Vysshikh Uchebnykh Zavedenii i Energeticheskikh Ob’edinenii SNG = Energetika. Proceedings of CIS Higher Education Institutions and Power Engineering Associations, 63 (6), 563–580 (in Russian). https://doi.org/10.21122/1029-7448-2020-63-6-563-580

2. Ivashechkin V. V., Krytskaya V. I., Anufriev V. N., Avrutin O. A. (2021) Methodology for Analyzing the Actual Technical Condition of Downhole Pumping Equipment. Enеrgеtika. Izvestiya Vysshikh Uchebnykh Zavedenii i Energeticheskikh Ob’edinenii SNG = Energetika. Proceedings of CIS Higher Education Institutions and Power Engineering Associations, 64 (3), 275–286 (in Russian). https://doi.org/10.21122/1029-7448-2021-64-3-275-286

3. Tugai A. M., Prokopchuk I. T. (1990). Water Supply from Underground Sources. Kyiv, Urozhai Publ. 264 (in Russian).

4. Plotnikov N. A., Alekseev V. S. (1990) Design and Operation of Groundwater Intakes. Moscow, Stroiizdat Publ. 256 (in Russian).

5. Tugai A. M., Oleinik O. Ya., Tugai Ya. A. (2004) Productivity of Water Intake Wells in Conditions of Colmatage. Kharkiv, 240 (in Russian).

6. Alekseev V. S., Grebennikov V. T. (1987) Restoring the Flow Rate of Water Intake Wells. Мoscow, Agropromizdat Publ. 239 (in Russian).

7. Milikhiker A. G. (1971) Sedimentation in Water Reduction Wells. Мoscow, Energiya Publ., 104 (in Russian).

8. Grundfos. Borehole pumps. Technical manual. Available at: https://www.pump-selection.ru/files/FilesGrundfos/books/6SP_1205.pdf (accessed 04 July 2022) (in Russian).

9. Ivashechkin V. V., Medvedeva J. A., Kondratovich A. N., Satsuta E. S. (2021) Basics of Calculation and Design of Two-Column Two-Filter Water Intake Wells. Nauka i tekhnika = Science & Technique, 20 (5), 410–419 (in Russian). https://doi.org/10.21122/2227-1031-2021-20-5-410-419

10. Ivashechkin V. V., Medvedeva Yu. A. (2021) Water Intake Well. Patent of Republic of Belarus No 23608 (in Russian).

11. Shevelev F. A., Shevelev A.F. (2016) Tables for Hydraulic Calculation of Water Pipes. 11th Ed. Moscow, Bastet Publ. 428 (in Russian).

12. State standard 3262-75. Steel Water and Gas Pipes. Technical specifications. Moscow, IPK Publishing House of Standards, 1997. 12 (in Russian).

13. State standard 33969-2016. Energy Efficiency. Evaluation of the Energy Efficiency of Pumping Systems. Moscow, Standartinform Publ., 2017. 45 (in Russian).