Preview

Mechanical Calculation of Flexible Wires Taking into Account Taps to Electrical Apparatuses

https://doi.org/10.21122/1029-7448-2021-64-2-109-120

Abstract

A method is proposed for the mechanical calculation of flexible wires of substation in the presence of one tap to an electrical apparatus located in the middle of the span, taking into account its real location. The technique takes into account the presence of tension insulators strings, different heights of the suspension of wires. The loads on the conductor and tap depend on the climatic regime and take into account wind and icy conditions, as well as temperature changes. The transition to another climatic regime is performed by solving the equation of state, taking into account the coefficients of the horizontal and vertical load of the given and initial regimes. Formulas are given for calculating load factors that take into account weight, wind and ice cover loads on wires and insulator strings, as well as the slope of the span. They are calculated for each climatic mode based on the actual location of the tap to the electrical apparatus and the forces from it to the busbar. It is shown that the calculation results are in good agreement with the proposed method and the computer program. Formulas are given for calculating the sag and horizontal deviations of the wires when the tap is located in the middle of the span. A method is proposed for calculating the components of the forces on the busbar from the tap, taking into account its real location in substation. Formulas for calculating these components are given for different variants of the tap orientation. Knowledge of the values of the components of concentrated forces from the tap allows to increase the accuracy of calculating the sag and tension of the substation wires. Formulas are given for calculating the coefficients of increasing the sag, taking into account the components of the forces from the tap.

About the Authors

Y. V. Bladyko
Belаrusian National Technical University
Belarus

Address for correspondence: Bladyko Yuri V. – Belаrusian National Technical University, 65/2, Nezavisimosty Ave., 220013, Minsk, Republic of Belarus.  Теl.: +375 17 292-71-93
eie@bntu.by



E. G. Ponomarenko
Belаrusian National Technical University
Belarus

Minsk



References

1. Bladyko Y. V. (2018) Mechanical Calculation of Flexible Wires when the Concentrated Forces are Replaced by a Distributed Load. Energetika. Izvestiya Vysshikh Uchebnykh Zavedenii i Energeticheskikh Ob’edinenii SNG = Energetika. Proceedings of the CIS Higher Education Institutions and Power Engineering Associations, 61 (2), 97–107. https://doi.org/10.21122/ 1029-7448-2018-61-2-97-107 (in Russian).

2. Bladyko Y. V. (2018) Mechanical Calculation of Flexible Wires when a Concentrated Load is Being Replaced with a Distributed One Taking into Account the Structural Elements. Energetika. Izvestiya Vysshikh Uchebnykh Zavedenii i Energeticheskikh Ob’edinenii SNG = Energetika. Proceedings of the CIS Higher Education Institutions and Power Engineering Associations, 61 (3), 220–234. https://doi.org/10.21122/1029-7448-2019-61-3-220-234 (in Russian).

3. Sergey I. I., Bladyko Y. V. (2018) Mechanical Calculation of Flexible Wires of Overhead Lines with Barrage Balls. Energetika. Izvestiya Vysshikh Uchebnykh Zavedenii i Energeticheskikh Ob’edinenii SNG = Energetika. Proceedings of the CIS Higher Education Institutions and Power Engineering Associations, 61 (4), 299–309. https://doi.org/10.21122/1029-7448-2018-61-4-299-309 (in Russian).

4. Bladyko Y. V. (2019) Mechanical Calculation of Flexible Wires of Overhead Lines with Aerial Barrage Balls in Different Climatic Regimes. Energetika. Izvestiya Vysshikh Uchebnykh Zavedenii i Energeticheskikh Ob’edinenii SNG = Energetika. Proceedings of the CIS Higher Education Institutions and Power Engineering Associations, 62 (1), 24–36. https://doi.org/10.21122/1029-7448-2019-62-1-24-36 (in Russian).

5. Bladyko Y. V. (2019) Accounting for Spacers in the Mechanical Calculation of Flexible Wires for Overhead Lines and Switchgears. Energetika. Izvestiya Vysshikh Uchebnykh Zavedenii i Energeticheskikh Ob’edinenii SNG = Energetika. Proceedings of the CIS Higher Education Institutions and Power Engineering Associations, 62 (3), 219–231. https://doi.org/10.21122/ 1029-7448-2019-62-3-219-231 (in Russian).

6. Bladyko Y. V. (2020) Mechanical Calculation of Flexible Wires of Spans with Different Tensioning Insulator Strings. Energetika. Izvestiya Vysshikh Uchebnykh Zavedenii i Energeticheskikh Ob’edinenii SNG = Energetika. Proceedings of the CIS Higher Education Institutions and Power Engineering Associations, 63 (1), 55–65. https://doi.org/10.21122/1029-7448-2020- 63-1-55-65 (in Russian).

7. Bladyko Y. V. (2020) Mechanical Calculation of Flexible Wires Loaded with Concentrated Loads. Energetika. Izvestiya Vysshikh Uchebnykh Zavedenii i Energeticheskikh Ob’edinenii SNG = Energetika. Proceedings of the CIS Higher Education Institutions and Power Engineering Associations, 63 (2), 103–115. https://doi.org/10.21122/1029-7448-2020-63-2-103-115 (in Russian).

8. Bladyko Y. V. (2020) Mechanical Calculation of Flexible Wires in the Presence of Horizontal Concentrated Loads. Energetika. Izvestiya Vysshikh Uchebnykh Zavedenii i Energeticheskikh Ob’edinenii SNG = Energetika. Proceedings of the CIS Higher Education Institutions and Power Engineering Associations, 63 (6), 500–514. https://doi.org/10.21122/1029-7448-2020-63-6-500-514 (in Russian).

9. Strelyuk M. I., Sergey I. I., Bladyko Y. V. (1983) Numerical Method for Calculating the Statics of a Flexible Busbars of Open Distribution Devices in Various Modes of Climatic Impacts. Energetika. Izvestiya Vysshikh Uchebnykh Zavedenii = Energetika. Proceedings of the CIS Higher Education Institutions, (8), 8–14 (in Russian).

10. Strelyuk M. I., Sergey I. I., Bladyko Y. V. (1988) Vector-Parametric Method of Mechanical Calculation of Flexible Current Wires of Electrical Installations of Power Systems. Matematicheskie Metody v Elektroenergetike: Materialy II Mezhdunar. Simpoz. Zakopane, 10–12 Noyab. 1988 [Mathematical Methods in the Electric Power Industry: Materials of the II International Simposium. Zakopane, 10–12 Nov. 1988]. Zakopane, 173–181 (in Russian).

11. Strelyuk M. I., Sergey I. I., Bladyko Y. V. (1995) Computer Aided Program of Mechanical Calculation of Flexible Conductors for Substations and Overhead Lines Design. New Electrical and Electronic Technologies and their Industrial Implementation: Proceedings of the International Conference, Lublin, 7–8 Sept. Lublin, Lublin Technical University, 15–19.

12. Strelyuk M. I., Sergei I. I., Bladyko Y. V. (1995) Numerical Method of Mechanical Calculation of Flexible Current Conductors of Power Units of Power Systems. Energetika. Izvestiya Vysshikh Uchebnykh Zavedenii = Energetika. Proceedings of the CIS Higher Education Institutions, (3–4), 21–29 (in Russian).

13. Sergey I. I., Ponomarenko E. G., Bladyko Y. V., Klimkovich P. I. (2015) Software Package for Mechanical and Electrodynamic Calculation of Flexible Current-Conductive Structures. Metodicheskie Voprosy Issledovaniya Nadezhnosti Bol'shikh Sistem Energetiki: Materialy Mezhdunar. Seminara im. Yu. N. Rudenko [Methodological Issues of Reliability Research for Large Energy Systems. Proceedings of the International Seminar Named after Yu. N. Rudenko]. Minsk, BNTU, 308–310 (in Russian).

14. Kachurin V. K. (1956) Flexible Threads with Small Sags. Moscow, Gostekhizdat Publ. 224 (in Russian).


Review

For citations:


Bladyko Y.V., Ponomarenko E.G. Mechanical Calculation of Flexible Wires Taking into Account Taps to Electrical Apparatuses. ENERGETIKA. Proceedings of CIS higher education institutions and power engineering associations. 2021;64(2):109-120. (In Russ.) https://doi.org/10.21122/1029-7448-2021-64-2-109-120

Views: 1797


Creative Commons License
This work is licensed under a Creative Commons Attribution 4.0 License.


ISSN 1029-7448 (Print)
ISSN 2414-0341 (Online)